• 全国中文核心期刊
  • 中国科技核心期刊
  • 美国工程索引(EI)收录期刊
  • Scopus数据库收录期刊
佘巍, 唐晓武. 用图像分析法研究有纺土工织物单向受拉时孔径的变化[J]. 岩土工程学报, 2012, 34(8): 1522-1526.
引用本文: 佘巍, 唐晓武. 用图像分析法研究有纺土工织物单向受拉时孔径的变化[J]. 岩土工程学报, 2012, 34(8): 1522-1526.
SHE Wei, TANG Xiao-wu. Change of pore size of woven geotextiles affected by uniaxial tension using image analysis method[J]. Chinese Journal of Geotechnical Engineering, 2012, 34(8): 1522-1526.
Citation: SHE Wei, TANG Xiao-wu. Change of pore size of woven geotextiles affected by uniaxial tension using image analysis method[J]. Chinese Journal of Geotechnical Engineering, 2012, 34(8): 1522-1526.

用图像分析法研究有纺土工织物单向受拉时孔径的变化

Change of pore size of woven geotextiles affected by uniaxial tension using image analysis method

  • 摘要: 现有反滤设计中保土准则使用土工织物未受拉时的等效孔径,但平面单向拉伸会导致该值变化,变大则不满足保土准则,变小则不满足透水准则及淤堵准则。有纺织物孔径由孔径分布曲线和特征孔径反映,采用数字图像分析法对两种有纺土工织物单向受拉时孔径变化进行精确测定。有纺织物被单向张拉至3%,6%,9%和12%的平面应变,随着拉应变的增加,两种有纺土工织物开孔面积率增大;孔径分布曲线向孔径大的方向移动;3种特征孔径值(O30,O50和O95)增大,其变化率都与拉应变呈近似线性关系,且小孔径部分相对于大孔径部分随拉伸应变的增长而增大较快。

     

    Abstract: The equivalent opening size tested under unstrained condition is used in the current retention criterion for design of geotextile filters. However, the equivalent opening size can be influenced by in-plane uniaxial tensile strain. The retention criterion cannot be satisfied when it gets larger, and the permeability criterion and the clogging criterion cannot be satisfied when it gets smaller.The opening size of woven geotextiles can be featured by the pore size distribution and characteristic opening sizes. The opening sizes of two uniaxially stretched woven geotextiles are measured accurately by means of the digital image analysis. The in-plane uniaxial tensile strains of the woven geotextiles are increased to 3%, 6%, 9% and 12%. The percent open areas of the woven geotextiles and three characteristic opening sizes (i.e., O30, O50 and O95) increase with the increase of the tensile strains. Accordingly, the pore size distributions shift to the direction of the larger open sizes. The change rates of characteristic opening sizes approximately linearly increase with the increase of the tensile strains, and smaller characteristic opening sizes have larger increase with the increase of the tensile strains.

     

/

返回文章
返回