• 全国中文核心期刊
  • 中国科技核心期刊
  • 美国工程索引(EI)收录期刊
  • Scopus数据库收录期刊
张幸幸, 张建民, 温彦锋. 长期交通荷载作用下路基沉降的实用计算方法[J]. 岩土工程学报, 2015, 37(11): 2067-2072. DOI: 10.11779/CJGE201511018
引用本文: 张幸幸, 张建民, 温彦锋. 长期交通荷载作用下路基沉降的实用计算方法[J]. 岩土工程学报, 2015, 37(11): 2067-2072. DOI: 10.11779/CJGE201511018
ZHANG Xing-xing, ZHANG Jian-min, WEN Yan-feng. Practical method to predict settlement of subgrade induced by long-term traffic loads[J]. Chinese Journal of Geotechnical Engineering, 2015, 37(11): 2067-2072. DOI: 10.11779/CJGE201511018
Citation: ZHANG Xing-xing, ZHANG Jian-min, WEN Yan-feng. Practical method to predict settlement of subgrade induced by long-term traffic loads[J]. Chinese Journal of Geotechnical Engineering, 2015, 37(11): 2067-2072. DOI: 10.11779/CJGE201511018

长期交通荷载作用下路基沉降的实用计算方法

Practical method to predict settlement of subgrade induced by long-term traffic loads

  • 摘要: 目前尚没有方法能很好地预测长期不规则交通荷载引起的路基沉降变形。土在长周次微小振幅荷载作用下产生塑性变形的机理尚不清楚,现有弹塑性理论也很难描述这种变形。基于等价黏弹塑性模型的理论,提出了一个实用的预测长期交通荷载作用下路基沉降的计算方法。等价黏弹塑性模型由两部分组成:一部分为黏弹性模型,用于计算地基的动力响应,采用了Ramberg-Osgood动剪切模量公式和Hardin- Drnevich阻尼比公式;另一部分为计算残余应变的经验公式。根据动三轴试验所揭示的无黏性土在长周次循环荷载作用下的变形特点,以及移动荷载作用下路基土单元动应力过程的特点,建立了本模型中计算残余应变的经验公式。在得到各单元的残余应变后,可结合有限元方法计算得到路基的沉降。

     

    Abstract: There are still no effective methods to predict the settlement of subgrades caused by long-term irregular traffic loads. The mechanism of the plastic deformation caused by slight long-term dynamic loads has not been understand. And the existing plastic theory can hardly involve this type of deformation. In order to solve this problem, a practical method is proposed based on an equivalent vicso-elasto-plastic model. The model consists of two components. The first is a visco-elastic model, in which dynamic modulus is determined by Ramberg-Osgood equations and the damping ratio is determined by the equation proposed by Hardin and Drnevich. The other is empirical equation determines the residual strain, which is based on the stress process in subgrade foundation caused by traffic loads and the characteristics of residual strain tested by dynamic triaxial tests. After the stress process is obtained using the finite element analysis, the residual strain of every element can be determined by the empirical equation, then the settlement of the subgrade can be predicted. A simple example is presented to illustrate this procedure.

     

/

返回文章
返回