• 全国中文核心期刊
  • 中国科技核心期刊
  • 美国工程索引(EI)收录期刊
  • Scopus数据库收录期刊
李建, 唐朝生, 王德银, 施斌, 裴向军. 基于单根纤维拉拔试验的波形纤维加筋土界面强度研究[J]. 岩土工程学报, 2014, 36(9): 1696-1704. DOI: 10.11779/CJGE201409017
引用本文: 李建, 唐朝生, 王德银, 施斌, 裴向军. 基于单根纤维拉拔试验的波形纤维加筋土界面强度研究[J]. 岩土工程学报, 2014, 36(9): 1696-1704. DOI: 10.11779/CJGE201409017
LI Jian, TANG Chao-sheng, WANG De-yin, SHI Bin, PEI Xiang-jun. Single fiber pullout tests on interfacial shear strength of wave-shape fiber-reinforced soils[J]. Chinese Journal of Geotechnical Engineering, 2014, 36(9): 1696-1704. DOI: 10.11779/CJGE201409017
Citation: LI Jian, TANG Chao-sheng, WANG De-yin, SHI Bin, PEI Xiang-jun. Single fiber pullout tests on interfacial shear strength of wave-shape fiber-reinforced soils[J]. Chinese Journal of Geotechnical Engineering, 2014, 36(9): 1696-1704. DOI: 10.11779/CJGE201409017

基于单根纤维拉拔试验的波形纤维加筋土界面强度研究

Single fiber pullout tests on interfacial shear strength of wave-shape fiber-reinforced soils

  • 摘要: 纤维/土界面间的力学作用特性是决定纤维加筋土工程性质的关键因素。为了改善纤维/土界面作用力,开发了一种新型的波形纤维作为加筋材料,并自主设计了一套拉拔试验装置,对单根纤维加筋土开展了多组拉拔试验,定量获得了波形纤维加筋土的拉拔特性及界面剪切强度,通过与传统直线形纤维对比,分析了波形纤维/土界面的力学作用机理,并从理论上探讨了波形纤维的最大临界加筋长度。结果表明:提出的单根纤维拉拔试验方法及设计的试验装置为研究纤维/土界面力学作用提供了有效的途径,试验结果具有较好的可重复性;直线形纤维的拉拔曲线呈典型的单峰特征,拉力达到峰值后迅速减小到残余值并逐渐趋于稳定,而波形纤维的拉拔曲线呈显著的多峰特征,曲线波长与纤维的波长基本一致;通过对比,波形纤维/土界面剪切强度明显高于直线形纤维,强度值提高了178%,极大改善了纤维的加筋效果,此外,波形纤维拉拔曲线各峰值对应的界面剪切强度及残余剪切强度随拉拔位移呈指数递减趋势;利用测得的纤维/土界面剪切强度,结合纤维自身的抗拉强度和一些假设条件,能确定纤维的最大临界加筋长度,对实际工程设计有一定参考意义。

     

    Abstract: The interfacial mechanical interaction between fibers and soils is the key factor controlling the engineering properties of fiber-reinforced soils. In order to improve thee mechanical properties of fiber-soil interface, a new wave-shape fiber is developed as a reinforcement material. An innovative pullout test device is designed. By applying this device, a series of single fiber pullout tests are carried out on fiber-reinforced soil samples. The pullout characteristics and interfacial shear strength of wave-shape fiber-reinforced soils are quantitatively obtained. As compared to the conventional straight fibers, the interfacial mechanical interaction character of wave-shape fiber-reinforced soils is analyzed. Moreover, the maximum critical reinforcement length and techniques of wave-shape fibers are discussed. The results show that the proposed single fiber pullout test method and the designed pullout test device are effective to quantify the interfacial mechanical behaviours of the fiber-reinforced soils, with simple operation and good repeatability. The pullout curves of straight fiber present a typical single peak characteristic. As the pullout load reaches the peak value, it decreases rapidly to the residual value, and then gradually reaches stabilization. However, the pullout curves of the wave-shape fibers present a typical characteristic of multiple peaks, and the wavelength of the curve is consistent with that of the wave-shape fibers. It is found that the interfacial shear strength of the wave-shape fiber-soil is significantly higher than that of the conventional straight fiber, and the corresponding strength increases by 178%. It indicates that the wave-shape fibers can dramatically improve the reinforcement benefit as compared with the straight fibers. In addition, the interfacial shear strength and residual shear strength, which are corresponding to the peak values of wave-shape fiber pullout curve, generally decrease exponentially with an increase in pullout displacement. According to the measured fiber-soil interfacial shear strength,

     

/

返回文章
返回